What size range will the drill collets hold? I used to good at grinding drills free-hand (before my eyes got old). I have difficulty with very small drill bits <1/8".
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: flattening chisel and plane backs, Ron Hock suggestion
August 05, 2010, 01:24:01 PM
I also read Ron Hock's comment in his sharpening book and I wonder what exactly his suggestion to Tormek is? My impression is that it has more to do with some sort of fixture attachment rather than the foot switch idea. It might be worth asking Ron on his website blog.
Pages1