which jig would you use to sharpen curved edge garden loppers? The edge looks like it is beveled at a 20 degree angle
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Skewed chisels
April 18, 2010, 12:36:11 AM
Jeff, question on what jig to use for skewed dovetail chisels -- do I need the SVK-50 or can I just use the flat edge jig and turn the chisel to the correct angle by lining it up on a straight line drawn on the sharpening stone?
#3
General Tormek Questions / Tormek and oil stones combination
April 01, 2010, 09:04:28 PM
Jeff, I have read (on other sites) other woodworkers who complement the Tormek sharpening process by ending with honing their tools on +4000 grit or higher oilstones or diamonds for the ultimate edge. Would you recommend this process or is it overkill?
Pages1