Once again Jeff, Thank you for your prompt reply. You have cleared everything up. It's a pity this explanation isn't in the booklets supplied.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: SVD-185 - shaft numbers
February 21, 2010, 02:18:39 PM
Thank you for the reply, I found this article, which seems to indicate that the shaft setting could be crucial.
http://www.woodturnerscatalog.com/woodturners/Images/pdfs/tormek.pdf
http://www.woodturnerscatalog.com/woodturners/Images/pdfs/tormek.pdf
#3
General Tormek Questions / SVD-185 - shaft numbers
February 20, 2010, 08:24:52 PM
All references drawn from handbook version 9.7. Can anyone tell me what the correlation is between the 'Jig' numbers page 73 (which says the numbers go from 0-5, but clearly shows a 6) and the numbers on the shaft. The only mention I could find was on page 72, (the stop ring can be set for a convex bevel).
Pages1