I recently purchased a BGM-100, TTS-100, and SVD-185. I fugured out the settings and am quite happy with the sharpening of a 1" and 3/4" roughing gouge, but can NOT figure out the settings to SHAPE and SHARPEN a 3/8" fingernail gouges. Can you advise?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com