Yes protrusion is at 75mm. The guide on the svd 185 needs to be reversed? It is the guide on the 185 that's stopping me to get closer when it is sliding on the tool rest. The tool rest is in the lower position grind stone going away from tool. When tool handle goes left the sharping end starts at approx. 3/4 from edge of grind stone to continuing the sharping tip leaves the grind stone. At approx. 45% the handle i should stop but the wing is not sharpened complete. Doing something wrong??
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Wood Turning / Re: Svd 185 will not let me stay on grindstone when doing a 1/2 Ellsworth grind
December 18, 2009, 09:36:21 PM #2
Wood Turning / Svd 185 will not let me stay on grindstone when doing a 1/2 Ellsworth grind
December 17, 2009, 08:01:17 PM
I have a new SVD185 with a six on the dail. My stone is 8 5/8" arm is 1 5/8" away from grindstone. When bowl gouge handle goes left, gouge end starts going off the right side of grindstone. Can you help?
Pages1