does anyone know a good way to sharpen mower blades on the Tormek? I have several to sharpen and can't find a jig that will hold the blades. Is there an alternate way of sharpening mower blades? thanks for any help.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: sharpening round blades
December 18, 2009, 01:08:36 PM
thanks for the suggestion, I will give it a try and let you know if it works.
#3
General Tormek Questions / sharpening round blades
December 17, 2009, 06:24:20 PM
I have several round cutoff blades @ 3" dia. w/ a single beveled edge of 15 deg. would anyone know of a fixture that would work on a Tormek? These blades are .055 thick x 3" dia. with a .500 thru hole in center. I need to find a way to sharpen these on a Tormek, any ideas would be appreciated. Jim 
Pages1