I sharpened my first bowl gouge and was generally happy with the results but one of the edges is slightly concave. I think it is because one side of the jig does not allow me to swing the tool as much as the other side. I hope that makes sense to anyone who has had this same problem. What can I do to remedy that problem? Thanks to any responders.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com