Messages

I went to Tormek's website and searched their dealer's list. Nothing is listed for this state.

I was trying to shape a skew chisel on the dry grinder with the bgm-100. I followed the instructions from the bgm-100 book and the one on the tts-100 jig. I could tell something was not right. So then I look in the tts-100 instruction manuel. I discovered on page 40 that the closed seat had been re-designed in 2006. It said the original closed seat (mine) should be shortened 10 mm or I could adjust the protusion by 10mm. I did the second choice. Is there going to be an update offered for the revised closed seat?
Thanks.
Jay

I am making a dry grinder setup like the one you provided for the review in W. D.  The  seven and one-half inches from the left side-- is this measured to the metal housing on this grinder or the the edge of the stone?  How far from the front edge is the grinder's base?

Thanks
Jay