Ripper! (as we say Down Under) Thanks again, Jeff.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Turning / Bouquets
September 09, 2009, 07:30:57 AM
G'day Jeff
I'm a newbie T-7 owner from Down Under, and signed up for this forum as part of the registration process. I just wanted to offer my compliments on the value of this forum and your very timely advice - in reading over the first few pages of turning tool posts, I have already come across the answers to two problems of mine! Thanks to you, I now know how to sharpen my round skews, and my "pyramid" point tool.
Any suggestions for the best way to sharpen that funny French tool, the Bedan?
I'm a newbie T-7 owner from Down Under, and signed up for this forum as part of the registration process. I just wanted to offer my compliments on the value of this forum and your very timely advice - in reading over the first few pages of turning tool posts, I have already come across the answers to two problems of mine! Thanks to you, I now know how to sharpen my round skews, and my "pyramid" point tool.
Any suggestions for the best way to sharpen that funny French tool, the Bedan?
Pages1