News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jessetab

Pages1
#1
Wood Turning / Re: Turning roughing gouges
August 13, 2009, 01:19:58 AM
Yes my first try made a kind of wave out of the edge. went back took a little more time and less pressure on the tool and was able to get the edge back. Big learning cerve. Wish someone gave hands on lessons.
Or that I would have taken shop years ago in high school. LOL

Jesse
#2
Wood Turning / Turning roughing gouges
August 12, 2009, 05:27:23 PM
Ok I am new to this and just got my sharpener the T7. My problem is when I sharpened my gouges I keep getting the edge curved. That is to say when you look at the gouge from a level position the edge is not flat. A slight curve is noticed . The edge is razor sharp but not straight. any pointers would be helpful.

Jesse
Pages1