News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - paulcomi

Pages1
#1
Wood Turning / Which jig for turning tools?
July 18, 2009, 05:35:13 PM
As a new user to the the Tormek system it appears that the universal jig is similar to the SVS-50 multi jig when it comes to sharpening turning tools, except that its more limited.

I'm thinking I can sharpen all my turning tools (I have a 6 pc HSS set with several gouges, skew, parting tool, scraper) with the SVS-50.

So, if the SVS-50 will sharpen fingernail gouges, why would one ever need the universal jig for gouges?

#2
General Tormek Questions / Thanks Jeff
July 07, 2009, 06:45:34 AM
I just bought a lightly used supergrind 2000 and it has the non micro adjust tool bar and the old style one knob bracket for horizontal clamping. Based on your recommendation, I just ordered both the new style two knob bracket and the micro adjust universal tool bar. I look forward to learning from you folks here and having a good experience with my new tormek.
Pages1