Jeff I bought the xb 100 to use with my dry 8" dry grinder. The instructions are to mount the xb-100 only on the tormek. I now realize the necessary instructions come with the full kit. Can I purchase the mounting instructions for the dry grinder or take a peek online? I want to get the horizontal and vertical location exact in relation to the grinder shaft center. Thanks PS the blackstone wheel is awesome.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Unclear on setting the svd 185
July 07, 2009, 05:22:03 AM
Do you point the arrow in the v-groove or on top in between the grooves? Also while I've got you can you get the same razor sharp edge with the new sb 250 Blackstone that I can with the sg-250. I have some Doug Thompson tools I am sharpening and the sg-250 is fine but it is barely in the water. Nearly time for a new wheel. Thanks Jeff.
Pages1