1/4 turn worked. Everthing is fine and with in tolerence. Thanks
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / New T-7, stone wheel wobbles
May 28, 2009, 01:30:16 PM
I just purchased a T-7 and the stone wheel wobbles. I took the wheel off and re-tightened according to the directions (couple of light taps with a hammer on the wrench to tighten the nut) and it still wobbles. I've noticed that the shaft has some play in it. Any suggestions?
Pages1