Giff all the jigs you have asked about will fit the T3
All the current stock should have the new SE-76
All the current stock should have the new SE-76
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: BGM-100
July 13, 2010, 06:10:54 AM
Phil another thing to take note is that the radius on the wheel is slightly different.
You are probably going from a 8" spark grinder to the 10" tormek so a slight difference there.
Nothing to worry about as you have used the spark grinder to form the shape and this has done all the hard work and saved a lot of time, now the Tormek will refine the shape and edge. It will over a very short time merge the bevel into one.
Sometimes it is hard to tell the difference between the two.
You are probably going from a 8" spark grinder to the 10" tormek so a slight difference there.
Nothing to worry about as you have used the spark grinder to form the shape and this has done all the hard work and saved a lot of time, now the Tormek will refine the shape and edge. It will over a very short time merge the bevel into one.
Sometimes it is hard to tell the difference between the two.
Pages1