Thanks Jeff,
Will try it next time.
Will try it next time.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / BGM-100
July 05, 2010, 12:40:15 PM
Got a BGM-100 yesterday and tried it out this morning.
What a difference in the time getting a profile and a sharp edge.
Well worth the *cost* for the time saved.
I am sure it a (small) setting problem but on the first 2 tools I did the angle was not
transferred exactly from the dry grinder to the wet grinder.
Thanks it does make life easier.
Phil
What a difference in the time getting a profile and a sharp edge.
Well worth the *cost* for the time saved.
I am sure it a (small) setting problem but on the first 2 tools I did the angle was not
transferred exactly from the dry grinder to the wet grinder.
Thanks it does make life easier.
Phil
Pages1