News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - MikeHathaway

Pages1
#1
General Tormek Questions / Nylon bushings, SVH-60
December 23, 2004, 04:37:10 AM
For two years now I've been sharpening everything I own, and most of the stuff the neighbors bring over.  As a result, the nylon bushings in the base plate of my straight edge jig (SVH-60) have become elongated.
Where can I buy replacements?

Mike
Pages1