Any tips on sharpening the blades for the Ring Master?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Turning / BGM-100 / TT -50
July 22, 2009, 03:39:30 PM
Can the TT-50 be used with the BGM-100 to true a bench grinder wheel?
#3
General Tormek Questions / Stone Grader Repair
July 20, 2009, 09:28:42 PM
Is their any of repairing my stone grader? I was setting up my BGM-100 to a new stand with my T -7 and turned both the grinder and T - 7 to see if they would vibrate a lot. To my surprise they vibrated very little! I walked to the other side of my shop to get something to test grind and herd a bang! There was enough vibration to vibrate my almost brand new stone grinder of the stand and onto the floor. It is broke in two big pieces and one smaller one. I was thinking that maybe I could glue the pieces together?
Pages1