News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - lym

#1
how much should i raise the tool support?
#2
thanks, that was a fast reply.

what i mean in the 2nd question is how do you keep the edge  angle of the tip consistent as it would be very hard to mount the blade (toward the tip or toward the handle) in the same position when resharpening.
#3
still on the learning curve with my t-7.  results are good and working toward perfect.  when resharpening, is it better to regrind every time or re hone?

also, i can see that with the angle finder, it's easy to get the same angle but what about the curved tip?  any hints as to how to keep that consistent?

thanks.