Thanks....I did try this already but because the curve is so great it is difficult for me to maintain a consistent bevel. Thanks for your help.
Rick
Rick
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re:Sharpening a Skinner Knife
December 22, 2003, 10:11:56 PM
When I try to follow the curve it does not keep it at the same angle. I will send a picture of the knife directly to your email account.
Rick
Rick
#3
General Tormek Questions / Sharpening a Skinner Knife
December 22, 2003, 01:43:23 AM
I just purchased a Tormek and have sharpened my main hunting knife successfully. However, I am having trouble with my skinner knife. The skinner knife I have is short (about 3.5" long) and has a major curve to it. I can set the Tormek to do the straight part of the knife but when I get to the curved part, lifting the knife handle does not work. What is the best way to sharpen a skinner knife?
Thanks in advance for your assistance.
Rick
Thanks in advance for your assistance.
Rick
Pages1