Thanks for the response. Will it be more prone to more frequent touch ups?? It would seem the edge would be more fragile than a microbeveled edge or does this all really matter in today's A2 steel??
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Hand Tool Woodworking / Bevel up planes
January 27, 2009, 02:50:29 AM
Is the Tormek hollow grind sutiable for bevel up planes ? I'm very fond of my Veritas BU jack and smoothing planes and I'm considing the T7.
Paul
Paul
Pages1