Thanks!
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Tormek 2000 and truing tool
October 11, 2010, 08:50:56 PM
Hi Jeff,
Thanks for that.
Isn't the diamond dresser different though?
Richard.
Thanks for that.
Isn't the diamond dresser different though?
Richard.
#3
General Tormek Questions / Tormek 2000 and truing tool
October 11, 2010, 06:44:55 AM
Hi,
I have an early model Supergrind 2000 and am using an ADV-50D Truing tool with a XB100 Horizontal base.
I like the idea of the newer truing tool. What parts do I need to run the new truing tool?
Thanks,
Richard.
I have an early model Supergrind 2000 and am using an ADV-50D Truing tool with a XB100 Horizontal base.
I like the idea of the newer truing tool. What parts do I need to run the new truing tool?
Thanks,
Richard.
#5
Wood Turning / Re: SVD-180 and SVD-185
December 29, 2008, 08:35:22 PM
Also here is an interesting link to a wet vs dry grinding study:
http://designer.webdzinz.co.nz/barryswoodturning/articles/sharpening.html
http://designer.webdzinz.co.nz/barryswoodturning/articles/sharpening.html
#6
Wood Turning / SVD-180 and SVD-185
December 29, 2008, 08:33:06 PM
Hi,
I have an early SVD-180. How is the SVD-185 different and can I upgrade the SVD-180?
Also I have play in the plastic/nylon sleeve that slides on the universal support. Is there a replacement part for this?
Thanks,
Rich.
I have an early SVD-180. How is the SVD-185 different and can I upgrade the SVD-180?
Also I have play in the plastic/nylon sleeve that slides on the universal support. Is there a replacement part for this?
Thanks,
Rich.
Pages1