Messages

Thanks Jeff,

The hole in my Square Edge Jig is not threaded, which probably explains the missing stop. I'm in Australia so I'll wait until my dealer returns from his break and I'm sure he'll sort it out for me.

Regards,
Ian.

Thanks for the reply Jeff,

I checked the packaging again. I'm definately missing the safety stop.

Should the stop have been screwed into the Square Edge Jig?

I'll follow it up with my local dealer. He is closed for the Christmas/New Year period at the moment.

Regards,
Ian.

My wife gave me a Tormek T-7 for Christmas. I have a question about the safety stops that are used in conjuction with the Square Edge Jig (SE-76). The Square Edge Jig that came with my T-7 is missing the safety stop that is shown at number 3 in the picture below.


Click thumbnail for larger image.

It appears as though the safety stop screws into a threaded hole in the end of the Universal Support. I assume therefore that the safety stop also screws into the Square Edge Jig for storage, as shown in the picture above.

The Square Edge Jig that came with my machine has a hole at the safety stop storage location that is indicated in the picture. However, this hole is not threaded.

Is the picture above correct? Should my T-7 have come with the safety stop that screws into the Universal Support. Should the safety stop have been attached to the Square Edge Jig as shown in the picture above? Does the safety stop screw into a threaded hole in the Square Edge Jig for storage?

Regards,
Ian S.