It's been awhile between projects, and I had to dust off my model 2000 to put a new edge on some chisels. I noticed quite a bit of play between my straight edge jig and the universal support rod. I don't recall this much play before, and never had a problem with putting on a nice, straight edge. Can the plastic inserts in the jig be easily replaced, and if so, where can I obtain them? Maybe this is my excuse to purchase the new square edge jig. I'm also considering the new threaded support rod. Any comments if the upgrade is worth the expense?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com