I am considering purchasing the 2006 w/handyman's package. Has anyone used the Tormek to sharpen cleavers; both a chinese style cleaver as well as what is known as a french cleaver? The latter has a continuous curve across almost 90 degrees from tip of cleaver to the bottom edge. Would the knife jig work even though this type of cleaver is almost 5 inches wide from cutting edge to top of blade? Thanks
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com