News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - rrdesigns

Pages1
#1
General Tormek Questions / Best RPM speed for hollow grinding
October 13, 2008, 11:26:45 PM
I have been trying to find out the Tormek RPM speed without success. I was told by my master craftsman woodworking instructor to seek out a hollow grind system with an RPM of 1700 or slower. He thinks the Tormek spins too fast. Any comments from anyone out there regarding this? He made his own from an old refrigerator motor. I would prefer not to have to go this route.
Pages1