I ment to ay the "Square Edge Jig" not the universal jig
Sorry
Sorry
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / universal jig
September 09, 2008, 10:41:52 AM
Hi all.. Just got a T7
Universal jig works great except on my Baily block plane blades... the blade is thin and doesnt get clamped down enough to lock the blade in... seems tlo be a gap in the device.. Suggestions? is the jig out of alignment or a miss casting??
Thanks
Ken
Universal jig works great except on my Baily block plane blades... the blade is thin and doesnt get clamped down enough to lock the blade in... seems tlo be a gap in the device.. Suggestions? is the jig out of alignment or a miss casting??
Thanks
Ken
Pages1