Hi jeoff thanks for your reply, no I was not using the stop bar. how do i identify this?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / help for new tormek user
July 13, 2008, 11:09:07 AM
Hi I have just bought a used 2000 tormek. It is in good condition but has not been used for a long time. I noticed that the stone was not true so thought I would true it up with the truing jig( the one you push across).
I filled the trough up with water several times, I guess the stone was absorbing it and started to try and true the stone up - only to manage to cut several grooves in the stone- please can someone offer me some help and advice. I do not have a manual. Does the stone need to be run in water for a sertain period after non use. what is the correct speed feed to true it up. I have removed the grooves with the grading stone but obviously need to true it up.
I filled the trough up with water several times, I guess the stone was absorbing it and started to try and true the stone up - only to manage to cut several grooves in the stone- please can someone offer me some help and advice. I do not have a manual. Does the stone need to be run in water for a sertain period after non use. what is the correct speed feed to true it up. I have removed the grooves with the grading stone but obviously need to true it up.
Pages1