OK - thanks will try that.
Cheers
Gidon
Cheers
Gidon
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re:Noise coming from grinder
July 10, 2008, 05:43:12 PM
Thanks Jeff for your prompt reply.
The noise isn't a vibration noise - it's a sort of soft grinding noise. I've checked the motor as you advised and the motor's fine. I've confirmed the noise is from the grit coming off the drive wheel - it's not a biggy but not heard this on other machines - have you?
Cheers
Gidon
The noise isn't a vibration noise - it's a sort of soft grinding noise. I've checked the motor as you advised and the motor's fine. I've confirmed the noise is from the grit coming off the drive wheel - it's not a biggy but not heard this on other machines - have you?
Cheers
Gidon
#3
General Tormek Questions / Noise coming from grinder
July 09, 2008, 12:25:15 PM
Hi
I have a T-7 and find that even without on pressure on either of the wheels there's a rough noise coming from the grinder. Taking off the honing wheel it looks like the drive wheel is shedding some of its rubber and I believe that this rubber "grit" is causing the noise?
Is this normal - anything I can do about it? It's happened almost from new (a few months ago).
Many thanks
Gidon
I have a T-7 and find that even without on pressure on either of the wheels there's a rough noise coming from the grinder. Taking off the honing wheel it looks like the drive wheel is shedding some of its rubber and I believe that this rubber "grit" is causing the noise?
Is this normal - anything I can do about it? It's happened almost from new (a few months ago).
Many thanks
Gidon
Pages1