I'm new to the Tormek and find that when I'm grinding plane blades, especially the #6 to #8 blades that I get water spilling all over the machine when I move the blades back and forth across the grinding wheel. I've considered putting the Tormek in a plastic bucket to keep the mess off my bench. Is there something I'm doing wrong?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com