News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - yukon-rose

#1
General Tormek Questions / S2000 motor removal
March 05, 2021, 05:16:29 PM
I just bought a Supergrind 2000 that is in serious need of an overhaul.

I would like to remove the motor without cutting any wires. In order to do that it appears that I need to take the motor apart.

If you've done that, please offer any suggestions on how you did it.

Thanks.

Gary

#2
General Tormek Questions / EZYlock Thread size?
February 23, 2021, 10:33:27 AM
What is the thread size of the EZYlock nut?
Is the thread a standard VEE shape (60 degree)?

Gary