Brand new Wood Workers Wonder Cbn Wheel 200 grit Only had it for five days - Used to hollow grind A2 steel. Four chisels, two plane irons, and half a set of planer blades. Already Shiny steel and smooth spots all along right side of wheel an some on left. Is this normal? I have no faith in this product right now. Any thoughts?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / LOOKING FOR A SINGLE GRADE AGGRESSIVE WHEEL
September 11, 2018, 01:50:50 AM
Hi
I'm looking to replace an SG-250 with a more aggressive stone wheel. I only use my Tormek to hollow grind the basic geometry of straight edge woodworking tools. I never use the Tormek method and polish the hollow grind. I always set a secondary bevel on a a flat stone. Hence, I have no need of a dual-grade stone. I want a stone that will cut faster and glaze less than the SG-250. Most of the steel I grind is A2, though I sometimes grind high speed steel planer knives. Any suggestions welcome.
Thanks
I'm looking to replace an SG-250 with a more aggressive stone wheel. I only use my Tormek to hollow grind the basic geometry of straight edge woodworking tools. I never use the Tormek method and polish the hollow grind. I always set a secondary bevel on a a flat stone. Hence, I have no need of a dual-grade stone. I want a stone that will cut faster and glaze less than the SG-250. Most of the steel I grind is A2, though I sometimes grind high speed steel planer knives. Any suggestions welcome.
Thanks
Pages1