Hi all, just after buying myself a t8 mostly for sharpening turning tools. My question is would most turners hone there tools after sharpening and if so why is the universal support not made so it extends over the grinding week and honing wheel then you would not have to take it out turn it around and reset the distance from wheel it makes spence to me.imterested to see what others think. Joe
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com