Using my new T4 machine I have ground a 9mm chisel and with the support in the horizontal mount I want then to hone the newly ground edge. I can't because depending on how you describe the problem, either the leather honing wheel is too small or the chisel is too short to reach the wheel. If I try to present the chisel to the leather honing wheel the square edge jig is blocked by the mounting bar which physically prevents the mount from rotating far enough.
I am delighted with the T4 but I can only conclude that either honing of chisels must be done freehand or I require another kind of jig to hold my chisels. Am I missing something here?
I am delighted with the T4 but I can only conclude that either honing of chisels must be done freehand or I require another kind of jig to hold my chisels. Am I missing something here?