News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - robert29

Pages1
#1
General Tormek Questions / Problem with SVD-005 upgrade kit for SVD-180 to SVD-185
November 25, 2014, 04:40:52 PM
I've bought the upgrade kit to bring my SVD-180 up to the SVD-185 and have a problem with it.
The new knob screw for the tool holder is too big in diameter to fit in the existing brass fitting on the top of the tool holder.
Measuring bothscrews, the original thread is 5.75 mm and the new one is 7.76 mm.
There is nothing in the instructions with the kit to deal with this - I had expected them to be interchangeable.
How do I get round this one ?

Regards,
Robert.
#2
General Tormek Questions / SVD-185 for Supergrind 1200
November 06, 2014, 09:24:21 PM
Hello,
Can an SVD-185 gouge jig be used on an Supergrind 1200 ?   I can't see anything listed about their compatibility.
Thanks,
Robert.
Pages1