Hi All,
Glad I found this site. My new T7 arrived yesterday and while unpacking it, a small chip of broken plastic fell out of the unit. Turns out, it's a small piece about the size of a quarter broken off of the plastic housing located right behind the grinding wheel. Nothing I think that will affect performance and not a big enough problem to return the unit I hope. If I were to ask for a new part sent from Tormek, I am not sure I would be able to get in there to replace it.
My main question is this: While looking for the broken area I noticed that the whole motor is slightly "loose" or has a small amount of back and forth movement when pressing with my hand. Is this normal for these units? Anything I need to worry about?
Regards,
David
Glad I found this site. My new T7 arrived yesterday and while unpacking it, a small chip of broken plastic fell out of the unit. Turns out, it's a small piece about the size of a quarter broken off of the plastic housing located right behind the grinding wheel. Nothing I think that will affect performance and not a big enough problem to return the unit I hope. If I were to ask for a new part sent from Tormek, I am not sure I would be able to get in there to replace it.
My main question is this: While looking for the broken area I noticed that the whole motor is slightly "loose" or has a small amount of back and forth movement when pressing with my hand. Is this normal for these units? Anything I need to worry about?
Regards,
David