News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Mike Goetzke

Pages1
#1
Wood Turning / SVS-50 Question
January 29, 2015, 08:25:39 PM
First off the Tormek system is still somewhat new to me. I sharpened my spindle roughing gouge last weekend with this jig and is it just me or does the "TORMEK" logo cast into the jig bother others too? The logo and not a flat surface rides against the bar giving it a rough unsteady ride. Maybe I'm doing something wrong? Guess I can just file it down but wanted to check here first.

Thanks,

Mike
#2
General Tormek Questions / Bowl Gouge - how to fix convex sides?
July 30, 2013, 04:18:16 PM
I'm new to turning. I'm working on some cherry bowls. I ground my gouge to #6 75mm hole A. It just doesn't look correct and I had a few catches. Any suggestions appreciated:

Pages1