The nut that holds the grinding wheel to the shaft on my T-7 is very hard to remove. Harder to loosen with the standard wheel installed than the Japanese Water wheel but hard on both and seems to be getting harder with use. I can see nothing wrong with the retainer or the shaft other than the retainer nut has a shallow circular groove on the back. Is this common and what is the fix.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com