The rubber drive wheel on my T7 keeps building up rubber compound on the motor shaft causing slippage. I have to remove the honing wheels and clean the motor drive shaft after approx. every two to three hours of use. Use is "not" continuous, 2-3 minutes here, 5 minutes there, etc. I have sanded the rubber drive wheel as suggested in other post, but it hasn't resolved the problem. How do I obtain a replace under warranty?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com