Hello everyone. I'm new to the tormek family, I just started using my own T-7 & am having a blast.
After a few days of playing around with my new machine, I've noticed my square edge jig
side wall set is not producing a square grind.
At first I had a 0.7mm wobble, fixed that with a 1/4 turn of my washer.
My motor was making a Pulsing noise, it's going away with time as I'm
breaking in the motor. My stone was up and down , but since I've used my truing jig
the stone has been perfect.
With the help of your forum and its member's I've fixed/solved most of the little bump and kinks.
But I was expecting to sit my tools snug on the side of the Square edge jig to produce a 90deg. grind....
I'm finding I have to adjust and slightly offset by eye. Is this normal?
Thank you for any tips you can give.
After a few days of playing around with my new machine, I've noticed my square edge jig
side wall set is not producing a square grind.
At first I had a 0.7mm wobble, fixed that with a 1/4 turn of my washer.
My motor was making a Pulsing noise, it's going away with time as I'm
breaking in the motor. My stone was up and down , but since I've used my truing jig
the stone has been perfect.
With the help of your forum and its member's I've fixed/solved most of the little bump and kinks.
But I was expecting to sit my tools snug on the side of the Square edge jig to produce a 90deg. grind....
I'm finding I have to adjust and slightly offset by eye. Is this normal?
Thank you for any tips you can give.