News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - demps

#1
Wood Turning / Sharpening a Raffan radius skew
November 04, 2012, 07:42:08 PM
Just got a 1 inch Raffan skew.  Struggling with the sharpening.   From mfg the included angle is 30degrees.   The tormek manual seems to indicate 75mm, 30degree on the jig, but that is not getting me close.   Alternative, the manual recommends 65mm, 30 deg, for a 45 degree included angle, for less experienced turners (like me).   I'm closer to the factory grind, with this set up, but still not there.
Help?    Looking for repeatable set up for this tool.