Topics

I know have a stock of Wider and Taller Universal Support Bars for sale via my website, these make sharpening wide cleavers and long carver knives a lot easier and possible as the std bar is too short and not wide enough.
You can purchase them via my website
https://www.sharpeningtraining.co.uk/ourshop/prod_6129672-Tormek-Extended-Universal-Support-Bar.html

I wonder if anyone can help  

I have a T7 and the drive wheel has just split clean in two.

Does anyone know where I can get a replacement in the UK, as I am REALLY stuck without this machine!!

I run a sharpening business, and for knives I use nothing else.

I get through a lot of stones, I do sharpen a lot of knives though as I run it as a business. But I would have thought that 60 knives taking off 5mm is excessive. I use both the std stone and the blackstone on a T7.
Is this normal?

I sharpen a lot of chinese cleavers, but the larger cleavers are too big for the Universal Support as it will not go up high enough to allow the correct angle to be set.

Any ideas other than holding it by hand, which I am doing.

I now have the Extended Universal Support Bars in stock and for sale.
You can purchase them via my website
http://www.sharpknives.co.uk/onlineshop/prod_4360851-Extended-Universal-Support-Bar.html