Topics

I have spent about 40 mins tonight and about 2 hours yesterday attempting to sharpen my new skew to the Tormek grind.  I still don't have one side done!

I have
1) trued the wheel a number of times (3, taking around 1mm off the wheel in the process) as if you do this fast it creates a rougher surface
2) held the black block against it (course side) for a long time (say around 1-3 mins each time)
3) tried the vertical and horizontal positions
4) put one hell of a lot of weight onto the tip - more so in the horizontal position however I put a lot o force onto it in the vertical one

I expected it to be slow, say an hour at most, but this absolutly daft.

Questions to all you Tormek types
1) Is there a dummy thing I'm doing here
2) have i missed some magic step out in the process
3) can stones just be faulty and not cut? 

Many thanks all

Miles

When using the platform (forgive me I'm not up to using the product codes etc yet!) in the horizontal position I find it hard not to have the tool dragged up the stone a bit.  This gives me a rather multi faceted look to the grind.  I'm not sure if this is important as I guess it does not impact the cutting edge but it does not look right!

Has anyone come up with a solution to this - I was thinking of a matching, parallel plat, possibly coated with something to make it hyper slippery which could be clamped gentle down on the top surface of the tool.  Thus you would be free to move the tool left and right but it would be unable to ride up the stone...  I certainly don't have the skills to make such a thing so I was wondering if anyone out there has already solved the problem?

Miles