I am considering purchasing an Ellsworth Bowl Gouge. Can this be sharpened with the Tormek jig (s) rather than the Ellsworth jig? Has anyone used this gouge for bowls and sharpened on the Tormek?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Older Model Supergrind 2000
March 15, 2009, 07:39:13 PM
I have a Model Supergrind 2000 that I have upgraded through the years. I bought it at the Woodworking Show in Nov 1998. Everything works great and I use it on chisles, plane blades, turning tools, etc. But, it is the rectangular body, not the slant front. Does Tormek have a decal to apply to the top of the unit to measure the wheel diameter? Or do I need to continue using my inch ruler and calculating the metric measurement? It's not hard, but a nice decal would be great for using with the WM 200.
Pages1