News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - edward

#1
Wood Turning / Roughing Gouge Grind
September 30, 2023, 09:56:32 PM
I had a roughing gouge that was working pretty good and I decided to sharpen it with the tormek t4.  I followed the marker method to sharpen. Now the gouge will not cut into the wood.  I have checked and even used the  settings P=75mm, SVS-50 open face and set the Universal Support with Hole A still the same result. 

I can't figure what I've done wrong.

Any help appreciated.