News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - themutleymoo

Pages1
#1
General Tormek Questions / Re: Cooling fan slipping
April 16, 2020, 02:45:19 PM
Spoken to Tormek and the solution is to glue the fan to the shaft or send it back to them to fix.  As I'm in the UK i've gone with the former!!  Fingers crossed it stays put now and a lot easier than a return.

cheers

richard
#2
General Tormek Questions / Re: Cooling fan slipping
April 14, 2020, 12:23:31 PM
Thanks Ken,  I've attached a photo of the fan as I think you might be taking about a different thing - I'll check tonight but will drop Tormek a note.

Cheers

Richard
#3
General Tormek Questions / Cooling fan slipping
April 14, 2020, 10:45:45 AM
Hi,  the cooling fan on my T4 keeps slipping and making contact with the housing.  I can push it back on the shaft and after the machine has run for a couple of mins it then slips back along.  Thought I'd try here before contacting Tormek. Any thoughts on what to do gratefully received!

Thanks

Richard
Pages1