News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - akira13

#1
Thanks for the advice - will look into this
#2
Hi There,

Not sure if this has been asked before so apologies if it has, My faithful heavy green super grind 2000 motor seems to have burnt itself out after many years of good chisel sharpening. Tonight when i was sharping any pressure i applied caused the wheel to stop and the motor was super hot to touch.

Is it possible to get a replacement for motor for this model or due to the cost would i be better of getting a new model. If a new model is the way to go what model would suit the wet wheel i currently have on the 2000 as it is still in good condition i would like to reuse it.

Thanks

Sean