what am I doing wrong here? using markers to find the right angle on the edge. as you see, the edge is fine on the first grind but completely wrong on the other side.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Hand Tool Woodworking / Re: Jigg for axs
February 23, 2018, 06:09:10 PM
sva 170 is for normal axes with about 10-20 cm length of ax head.These axes on the picture are 20-40cm long. So the 170 jig comes for the stone, so I do not get the right angle on the edge.
#3
Hand Tool Woodworking / Jigg for axs
February 23, 2018, 05:47:30 PM
is there anyone with a good idea of a jig for such axes
Pages1