News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - essentian

#1
Hey All,

I recently took the pluge and invested in a T8 - I've had a dabble with it though I wanted to check a few things before spending more time with it! 

1. Is the SG-250 supposed to require truing out of the box? Mine seems to have a slight convex profile, and also if I set the USB a couple of mm off the stone, I can see that it's not quite a uniform diameter.

2. I'm sure the instructions say to lift the water tray to the max height when running the machine, though on mine this causes the tray to hit the bottom of the stone. Should this be the case, or have I misunderstood the instructions?

Cheers, John