News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Gary M.

Pages1
#1
General Tormek Questions / Re: Suggestions for UTS Lubricant?
March 13, 2012, 07:50:30 PM
Easy enough, thanks.
#2
General Tormek Questions / Re: Suggestions for UTS Lubricant?
March 13, 2012, 01:19:53 PM
Hi Jeff, Do you buff the UTS with the honing wheel or just wipe the compound on with a rag?

Thanks,
Gary
#3
General Tormek Questions / Re: Main Shaft Grease
March 08, 2012, 12:30:34 PM
Thanks for the feedback gentlemen. Much appreciated.

Regards,
Gary
#4
General Tormek Questions / Re: Main Shaft Grease
February 23, 2012, 06:05:15 AM
Hi Mike,  Where do you buy Super Lube?
#5
General Tormek Questions / Main Shaft Grease
February 22, 2012, 03:11:14 PM
Hello, New Tormek T7 user here. Been getting acquainted with my machine by sharpening some old knives and scissors which had some rust on them. I noticed that some of the rusty water dripped down between the collar and micro threads and decided to start a colony. That's a no-no so I decided to disassemble the machine and give the inside of the collars and the micro threads a cleaning and spritz of WD-40. Then I noticed that the main shaft grease that the stone mounts to is dry.

So my question is, should I wipe the dry stuff off and apply some fresh? If so, what type grease is recommended? Will any petroleum based lube work?

Thanks,
Gary
Pages1