Well it took a while until I got around to it, but I took Jeff's advice and it worked perfectly. I ground the back side and then honed both sides using the leather wheel and the knives are once again razor sharp. Thanks everyone.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Converting Serrated Blades to Straight?
January 01, 2011, 04:15:28 PM
Thanks Everyone. I'll give it a go and post my results.
#3
General Tormek Questions / Converting Serrated Blades to Straight?
December 13, 2010, 07:51:05 PM
I have several JA Henckels serrated edge knives that are no longer sharp. Basically they are now trash, unless I can convert them to straight edge.
I recently purchased a T-7 and in the past few hours sharpened evey knife I own to razor sharpness! I started with an old kitchen knife that would not cut a thing and it can now slice anything paper thin. Next on the list are my wood working chisels. The machine is simply amazing!
Has anyone converted a serrated edge knive to a straight edge? If so did it work and how well?
Thanks in advance
-Eric
I recently purchased a T-7 and in the past few hours sharpened evey knife I own to razor sharpness! I started with an old kitchen knife that would not cut a thing and it can now slice anything paper thin. Next on the list are my wood working chisels. The machine is simply amazing!
Has anyone converted a serrated edge knive to a straight edge? If so did it work and how well?
Thanks in advance
-Eric
Pages1